If 50000 J of heat are added during a Isothermal process, where the volume goes from 4 L to 6 L and the pressure goes from 360000 Pa to 700000 Pa

Brades exam guidelines exam instructions billing & payments & support question 6 of 20 : select the best answer for the question use this illustration to answer the question below. forms & resources al programs 9 ww linics 6. in the circuit shown in the figure above, suppose that the value of r, is 100k, and the value of r2 is 470 kq. at which of the following locations in the circuit would you measure the highest voltage with your meter? rvices 999999 a. between points b and c b. between points a and b c. between points b and e d. between points a and c eredu mark for review (will be highlighted on the review page) mend < < previous question next question

Arefrigerator uses r-134a as the working fluid and operates on the ideal vapor-compression refrigeration cycle except for the compression process. the refrigerant enters the evaporator at 120 kpa with a quality of 34 percent and leaves the compressor at 70°c. if the compressor consumes 450 w of power, determine (a) the mass flow rate of the refrigerant, (b) the condenser pressure, and (c) the cop of the refrigerator. (0.00644 kg/s, 800 kpa, 2.03)

Does current flow through or across a resistor?