subject
Physics, 03.09.2021 17:20 jaylasmith884

A fisherman notices that his boat is moving up and down periodically without any horizontal motion, owing to waves on the surface of the water. It takes a time of 2.40 s for the boat to travel from its highest point to its lowest, a total distance of 0.670 m . The fisherman sees that the wave crests are spaced a horizontal distance of 6.50 m apart. Required:
a. How fast are the waves traveling?
b. What is the amplitude A of each wave?

ansver
Answers: 1

Another question on Physics

question
Physics, 21.06.2019 17:10
Aspecial electronic sensor is embedded in the seat of a car that takes riders around a circular loop-the-loop ride at an amusement park. the sensor measures the magnitude of the normal force that the seat exerts on a rider. the loop-the-loop ride is in the vertical plane and its radius is 23 m. sitting on the seat before the ride starts, a rider is level and stationary, and the electronic sensor reads 740 n. at the top of the loop, the rider is upside down and moving, and the sensor reads 370 n. what is the speed of the rider at the top of the loop?
Answers: 1
question
Physics, 22.06.2019 14:30
Which of the following changes will increase the capacitance of a parallel-plate capacitor? (there could be more than one correct choice.) a) increase the charge on the plates b) decrease the poten5al between the plates c) increase the potential between the plates d) introduce a dielectric material between the plates e) decrease the separation between the plates
Answers: 3
question
Physics, 22.06.2019 18:30
Adisk with a radius of r is oriented with its normal unit vector at an angle q with respect to a uniform electric field. which of the following would result in an increase in the electric flux through the disk? check all that apply? a. increasing the area of the disk b. decreasing the given orientation angle of the disk c. decreasing the strength of the electric field d. increasing the given orientation angle of the disk, but not exceeding an angle of 90
Answers: 1
question
Physics, 23.06.2019 06:30
Asquare isothermal chip is of width w=5 mm on a side and is mounted in a substrate such that its side and back surfaces are well insulated; the front surface is exposed to the flow of a coolant at tinf=15 °c. from reliability considerations, the chip temperature must not exceed t=85 °c. if the coolant is air and the corresponding convection coefficient is h=200 w/m2 x k, what is the maximum allowable "power" of the chip? if the coolant is a liquid for which h=3000 w/m2 x k, what is the maximum allowable power of the chip?
Answers: 2
You know the right answer?
A fisherman notices that his boat is moving up and down periodically without any horizontal motion,...
Questions
question
Biology, 20.12.2019 07:31
Questions on the website: 13722361