Worksheet 6 Gravity
Fill in the blank spaces

Gravity is a "a). .force"
which acts on objects without
b). ..them. Gravitational
force c). .(attracts/repels)
every object in the Universe.
Gravity is what makes everything near the
Earth d. . Gravity holds
the Earth in orbit around the e).
and holds all the stars together in a
f)
Gravity pulls on everything which has
g) . This is the amount matter
in an object, measured in units of h).
Your weight is the i).
..due to
j). ..pulling on your mass.
The k)...
...of any object stays the
same, but its 1). .changes
depending on where it is.

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).

the box does not move because you need to use a force greater than 300 n. you are only using 50 n. it needs to at least be 301 n for the box to move because then it is an unbalanced force and it will move the way that the greater force is pushing it. if you use only 300 n it will be a balanced force and will not move because the force you are exerting on the   box is the same as its force.

hope this !

im sorry if i went too in depth, i am going to include a link to a video on khan academy that will explain this.   hope that you like the video and that it explains more in detail to you.

that is the link.