subject
Physics, 23.08.2021 20:00 CarQuestionl506

In the past, most children who went sledding in the winter snow in Verland used wooden sleds with runners and steering bars. Ten years ago, smooth plastic sleds became popular; they go faster than wooden sleds but are harder to steer and slow. The concern that plastic sleds are more dangerous is clearly borne out by the fact that the number of children injured while sledding was much higher last winter than it was ten years ago. Which of the following, if true in Verland, most seriously undermines the force of the evidence cited?
(A) A few children still use traditional wooden sleds.
(B) Very few children wear any kind of protective gear, such as helmets, while sledding.
(C) Plastic sleds can be used in a much wider variety of snow conditions than wooden sleds can.
(D) Most sledding injuries occur when a sled collides with a tree, a rock, or another sled.
(E) Because the traditional wooden sled can carry more than one rider, an accident involving a wooden sled can result in several children being injured.

ansver
Answers: 3

Another question on Physics

question
Physics, 21.06.2019 21:50
What is the length x of the side of the triangle below? (hint: use the cosine function)
Answers: 1
question
Physics, 22.06.2019 03:00
Isla’s change in velocity is 30 m/s, and hazel has the same change in velocity. which best explains why they would have different accelerations? isla had negative acceleration, and hazel had positive. isla had a different time than hazel. isla had positive acceleration, and hazel had negative. isla went a farther distance than hazel.
Answers: 1
question
Physics, 22.06.2019 12:00
Asolid round steel rod 6.25 mm in diameter and 375 mm long is rigidly bonded to the end of solid square brass rod 25 mm on a side and 300 mm long. the geometric axes of the bare are along the same line. an axial tensile force of 5.4 kn is applied at the extreme ends of the assembly. for steel e = 200 gpa and for brass e = 90 gpa. determine the total elongation for the assembly.
Answers: 1
question
Physics, 22.06.2019 15:20
Acarpenter builds an exterior house wall with a layer of wood 2.9 cm thick on the outside and a layer of styrofoam insulation 2.3 cm thick on the inside wall surface. the wood has k=0.080w/(m⋅k), and the styrofoam has k= 0.010 w/(m⋅k). the interior surface temperature is 19.0 ∘c , and the exterior surface temperature is -15.0 ∘c . a.)what is the temperature at the plane where the wood meets the styrofoam? celsius b.)what is the rate of heat flow per square meter through this wall? /m^2
Answers: 2
You know the right answer?
In the past, most children who went sledding in the winter snow in Verland used wooden sleds with ru...
Questions
question
Geography, 24.04.2021 15:40
question
Mathematics, 24.04.2021 15:40
question
Mathematics, 24.04.2021 15:50
Questions on the website: 13722359