Physics, 14.08.2021 20:10 shelbybibb99

Physics please help I don’t understand

Answers: 2

Show answers

Another question on Physics

Physics, 21.06.2019 17:20

You have been called to testify as an expert witness in a trial involving a head-on collision. car a weighs 1515 lb and was traveling eastward. car b weighs 1125 lb and was traveling westward at 44.0 mph. the cars locked bumpers and slid eastward with their wheels locked for 22.5 ft before stopping. you have measured the coefficient of kinetic friction between the tires and the pavement to be 0.750 . how fast (in miles per hour) was car a traveling just before the collision? (this problem uses english units because they would be used in a u.s. legal proceeding.)

Answers: 3

Answer

Physics, 22.06.2019 00:50

Acave rescue team lifts an injured spelunker directly upward and out of a sinkhole by means of a motor-driven cable. the lift is performed in three stages, each requiring a vertical distance of 10.0 m: (a) the initially stationary spelunker is accelerated to a speed of 4.90 m/s; (b) he is then lifted at the constant speed of 4.90 m/s; (c) finally he is decelerated to zero speed. how much work is done on the 68.0 kg rescue by the force lifting him during each stage?

Answers: 1

Answer

Physics, 22.06.2019 21:00

Ais a machine that makes work easier when a single force is applied. a simple machine b compound machine c endangered machine d complex machine

Answers: 2

Answer

Physics, 23.06.2019 07:00

Conventional hot-water heaters consist of a tank of water maintained at a fixed temperature. the hot water is to be used when needed. the drawback is that energy is wasted because the tank loses heat when it is not in use, and you can run out of hot water if you use too much. some utility companies are encouraging the use of on-demand water heaters (also known as flash heaters), which consist of heating units to heat the water as you use it. no water tank is involved, so no heat is wasted. a typical household shower flow rate is 2.50 gal/min (9.46 l/min ) with the tap water being heated from 51.0 ˚f (10.6 ˚c) to 120 ˚f (48.9 ˚c) by the on-demand heater.what rate of heat input (either electrical of from gas) is required to operate such a unit, assuming that all the heat goes into the water?

Answers: 3

Answer

You know the right answer?

Physics please help I don’t understand
...

Questions