subject
Physics, 18.07.2021 08:40 xelynncaldera

The primary purpose of a switch in a circuit is to . A)either open or close a conductive path
B)change a circuit from parallel to series
C)change a circuit from series to parallel
D)store a charge for later use

ansver
Answers: 2

Another question on Physics

question
Physics, 21.06.2019 22:00
There is a theory that indicates that dinosaurs became extinct when about 65 million years ago, a large asteroid hit the earth surface. dust caused by this collision blocked the sunlight reaching the earth's surface and many forms of life became extinct due to the cold. fearing this threat, how large the radius of an asteroid should you be looking for if the dangerous asteroid size is approximately the same as the one that killed the dinosaurs? available data suggests that about 18% of that asteroid's mass ended up as a dust spread evenly over earth after eventually settling out of the upper atmosphere. about 0.0180 g/cm^2 of dust, which is chemically different than the earth's rock, covered the earth's surface. typical asteroids have a density of about 1.9 g/cm^3. now that we know the size of the asteroid, how much energy was released during impact, assuming all of it was just the kinetic energy of the asteroid right before the impact?
Answers: 1
question
Physics, 22.06.2019 15:20
A20 cm long spring is attached to a wall. the spring stretches to a length of 22 cm when you pull on it with a force of 100 n. what is the spring constant
Answers: 3
question
Physics, 22.06.2019 23:40
Acar jack with a mechanical advantage of 6 needs to produce an output force of 600 n to raise a car. what input force is required? 6 n 100 n 600 n 3,600 n
Answers: 2
question
Physics, 23.06.2019 01:30
Six pendulums of mass mand length las shown are released from rest at the same angle theta from vertical. rank the pendulums according to the numberof complete cycles of motion each pendulum goes through perminute. a. l= 1m m=2kg b. l= 4m m=1 kg c. l= 2 m m= 2 kg d. l= 1 m m= 4 kg e. l= 2 m m = 4 kg f. l= 4m m = 4kg
Answers: 3
You know the right answer?
The primary purpose of a switch in a circuit is to . A)either open or close a conductive path
...
Questions
question
Mathematics, 24.04.2020 16:42
question
Mathematics, 24.04.2020 16:42
question
Mathematics, 24.04.2020 16:43
Questions on the website: 13722360