The diagram shows the electric field lines surrounding two positive point charges. If the charge on the right were replaced with a negative charge, which of these would need to change to make a correct representation of the electric fields? (Choose all that apply) A. Field Lines would full in between the two charges (instead of leaving a blank area at point D
B. The field lines around both charges would change direction.
C. The field lines would get closer together
D. The arrows on the field lines surrounding the negative charge would need to point toward instead of away from the charge.

Part f - example: finding two forces (part i) two dimensional dynamics often involves solving for two unknown quantities in two separate equations describing the total force. the block in (figure 1) has a mass m=10kg and is being pulled by a force f on a table with coefficient of static friction îľs=0.3. four forces act on it: the applied force f (directed î¸=30â above the horizontal). the force of gravity fg=mg (directly down, where g=9.8m/s2). the normal force n (directly up). the force of static friction fs (directly left, opposing any potential motion). if we want to find the size of the force necessary to just barely overcome static friction (in which case fs=îľsn), we use the condition that the sum of the forces in both directions must be 0. using some basic trigonometry, we can write this condition out for the forces in both the horizontal and vertical directions, respectively, as: fcosî¸â’îľsn=0 fsinî¸+nâ’mg=0 in order to find the magnitude of force f, we have to solve a system of two equations with both f and the normal force n unknown. use the methods we have learned to find an expression for f in terms of m, g, î¸, and îľs (no n).

In positive numbers less than 1, the zeros between the decimal point and a non-zero number are blank significant

What type of relationship exists between the length of a wire and the resistance, if all other factors remain the same? o a. resistance is directly related to length. ob. resistance is directly related to the square of the length. c. resistance is inversely related to the length. d. resistance is inversely related to the square of the length. reset next