Physics, 16.06.2021 14:00 stephanieboyd

Which of the following changes would double the force between two charged particles? A. Doubling the amount of charge on each particle
B. Increasing the distance between the particles by a factor of 2
C. Decreasing the distance between the particles by a factor of 2
D. Doubling the amount of charge on one of the particles

Answers: 2

Show answers

Another question on Physics

Physics, 22.06.2019 07:00

Hen a gfci receptacle device is installed on a 20-ampere branch circuit (12 awg copper), what is the minimum volume allowance (in cubic inches) required for conductor fill for each conductor in the outlet box?

Answers: 1

Answer

Physics, 22.06.2019 15:30

What are the necessary conditions for fusion?

Answers: 1

Answer

Physics, 22.06.2019 19:50

The heater element of a 120 v toaster is a 5.4 m length of nichrome wire, whose diameter is 0.48 mm. the resistivity of nichrome at the operating temperature of the toaster is 1.3 × 10-6 ω·m. the toaster is operated at a voltage of 120 v. (a) what is the power drawn by the toaster? (b) if the cost of electricity is 12 ¢ per kilowatt-hour, and it takes 2 minutes to toast bread, how much does it cost for toasted bread? (c) when the heater element is at room temperature, is the resistivity in the nichrome wire greater than, less than, or equal to it’s resistivity when at operating temperature? explain.

Answers: 3

Answer

Physics, 22.06.2019 23:00

Acommon technique in analysis of scientific data is normalization. the purpose of normalizing data is to eliminate irrelevant constants that can obscure the salient features of the data. the goal of this experiment is to test the hypothesis that the flux of light decreases as the square of the distance from the source. in this case, the absolute value of the voltage measured by the photometer is irrelevant; only the relative value conveys useful information. suppose that in part 2.2.2 of the experiment, students obtain a signal value of 162 mv at a distance of 4 cm and a value of 86 mv at a distance of 5.7 cm. normalize the students' data to the value obtained at 4 cm. (divide the signal value by 162.) then calculate the theoretically expected (normalized) value at 5.7 cm.

Answers: 2

Answer

You know the right answer?

Which of the following changes would double the force between two charged particles? A. Doubling th...

Questions