fake cord made for bungee jumping is being tested a weight of 800 Newtons is attached to one end of the budgie cord then the weight is released from the tall tower and it moves downwards when the elastic cord is fully extended it exert an opposite force of 900 and on the way what would happen if the elastic cord extended a maximum force of only 700 newtons on the weight​

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).

because it says use -2,0,and 2 for x, we can plug those numbers into the equation. y/4=3/4(-2)+2   y/4= -1 1/2 +2 now to get x by itself, we can multiply each side by 4. y=-6+8 which equals y=2 when x=-2. now you can do the same thing with 0 and 2 as x. you get y=8 when x=0 and y=14 when x=2.

x   |   y

-2 |   2

0   |   8

2   |   14

the current is 0.6

voltage ÷ resistance = current

so 12 ÷ 20 = 0.6