Physics, 20.05.2021 02:40 madmatt873

50 POINTS AND BRAINLIEST!! How would interactions between the hydrosphere and atmosphere impact locations where the

humidity tends to be lower?

a. The amount of cloud cover in the hydrosphere would be higher because it has not condensed

from the atmosphere.

b. The amount of cloud cover in the hydrosphere would be lower because it has been condensed

from the atmosphere.

c. The amount of water vapor in the atmosphere would be higher because it has been precipitated

from the hydrosphere.

d. The amount of water vapor in the atmosphere would be lower because it has not evaporated

from the hydrosphere.

Answers: 2

Show answers

Another question on Physics

Physics, 22.06.2019 01:10

Suppose that two tanks, 1 and 2, each with a large opening at the top, contain different liquids. a small hole is made in the side of each tank at the same depth 1.57 m below the liquid surface, but the hole in tank 2 has 2.49 times the cross-sectional area of the hole in tank 1. (a) what is the ratio ρ1/ρ2 of the densities of the liquids if the mass flow rate is the same for the two holes? (b) what is the ratio rv1/rv2 of the volume flow rates from the two tanks? (c) at one instant, the liquid in tank 1 is 14.9 cm above the hole. if the tanks are to have equal volume flow rates, what height above the hole must the liquid in tank 2 be just then?

Answers: 3

Answer

Physics, 22.06.2019 07:30

Some material consisting of a collection of microscopic objects is kept at a high temperature. a photon detector capable of detecting photon energies from infrared through ultraviolet observes photons emitted with energies of 0.3 ev, 0.5 ev, 0.8 ev, 2.0ev, 2.5ev, and 2.8ev. these are the only photon energies observed. (a) draw and label a possible energy-level diagram for one of the microscopic objects, which has four bound states. on the diagram, indicate the transitions corresponding to the emitted photons. explain briefly. (b) would a spring–mass model be a good model for these microscopic objects? why or why not? (c) the material is now cooled down to a very low temperature, and the photon detector stops detecting photon emissions. next, a beam of light with a continuous range of energies from infrared through ultraviolet shines on the material, and the photon detector observes the beam of light after it passes through the material. what photon energies in this beam of light are observed to be significantly reduced in intensity (“dark absorption lines”)? explain briefly.

Answers: 3

Answer

Physics, 22.06.2019 15:30

How many neutrons does element x if it’s atomic number is 28 and its mass number is 87

Answers: 1

Answer

Physics, 22.06.2019 17:30

When using the scientist method, which step comes last?

Answers: 2

Answer

You know the right answer?

50 POINTS AND BRAINLIEST!! How would interactions between the hydrosphere and atmosphere impact loc...