subject
Physics, 07.05.2021 17:20 junior1391

A student is swinging on a swing at the playground. At their maximum height, they are 2.3 meters from the ground. When they reach that height, they are not moving for a moment. What is their potential energy at this maximum height if their mass is 60 kg? J. Use g = 10m/s/s for your calculation.

ansver
Answers: 1

Another question on Physics

question
Physics, 21.06.2019 19:30
Act has a 1200: 5 or 240: 1 turns ratio. it is short circuited. what is the maximum current at 1200a primary if we put a 100ohm resistor across the secondary end of the ct. use it as current source circuit.
Answers: 2
question
Physics, 22.06.2019 00:00
During physical science, ms. greene challenged her students to produce an energy transformation. james and jill wrapped a 4-inch nail with a coil of fifty turns of wire. they connected one end of the coil to one terminal of a knife switch. they connected the other terminal of the knife switch to the battery. finally, they connected the end of the coil to the other terminal of the battery. james held the tip of a 1-inch nail near the flat end of the 4-inch nail. jill closed the knife switch quickly and then opened it. the 1-inch nail was pulled toward the 4-inch nail. what is the best explanation of why the nail moved? a) electrical energy was converted to mechanical energy in the 1-inch nail. b) the 4-inch nail became an electromagnet and the magnetic force attracted the 1-inch nail. c) the electric current in the 4-inch nail was converted to mechanical energy in the 1-inch nail. d) the 4-inch nail had a positive charge and the 1-inch nail had a negative charge. opposites attracted.
Answers: 1
question
Physics, 22.06.2019 01:40
Crowbar of 5 metre is used to lift an object of 800 metre if the effort arm is 200cm calculate the force applied
Answers: 1
question
Physics, 22.06.2019 02:50
Steam is generated in a boiler of a cogeneration plant at 10 mpa and 450°c at a steady rate of 5 kg/s. in normal operation, steam expands in a turbine to a pressure of 0.5 mpa and is then routed to the process heater, where it supplies the process heat. steam leaves the process heater as a saturated liquid and is pumped to the boiler pressure. in this mode, no steam passes through a condenser, which operates at 20 kpa. (a) determine the power produced in the turbine and the rate at which process heat is supplied in this mode. (b) determine the power produced in the turbine and the rate of process heat supplied if only 60 percent of the steam is routed to the process heater and the remainder is expanded to the condenser pressure. (3.32 mw; 9.69 mw; 4.25 mw; 5.82 mw)
Answers: 3
You know the right answer?
A student is swinging on a swing at the playground. At their maximum height, they are 2.3 meters fro...
Questions
question
History, 26.05.2021 01:00
question
Mathematics, 26.05.2021 01:00
question
Mathematics, 26.05.2021 01:00
Questions on the website: 13722367