The uniform rectangular stone block with b=1.2mand h=0.9mis released from rest with its center of mass Gdirectly above the supporting corner. Determine the angular velocity ′of the block about the corner Aimmediately after impact assuming that Aremains in contact with the ground. Also assume that contact occurs at the corners only and that no slipping takes place. What fraction |ΔE|/Eof energy is lost in the impact?

Avehicle has an oil leak that is causing the entire oil pan to be wet, but inspection reveals no exact source after cleaning off the oil residue. technician a says to install a fluorescent dye in the crankcase and operate the engine, then re-inspect for leaks with a special light (black light). technician b says the oil leak may be coming from a source at the top of the engine, such as a valve cover gasket. who is correct?

Which lists the fundamental forces in order, from strongest to weakest? strong nuclear, weak nuclear, electromagnetic, gravitational strong nuclear, electromagnetic, weak nuclear, gravitational gravitational, weak nuclear, electromagnetic, strong nuclear electromagnetic, gravitational, strong nuclear, weak nuclear

Find the steady-state temperature at the center of the plate = /2, = /2) for sums of w from n=1 to n=19 (only odd values). find the value of n for which the change in /2, /2) is less than 1% from the value at the previous n. at this point, we consider the solution converged. does the value of the temperature at the center seem reasonable? in this part, the values of x and y are constant scalar values. you should produce a plot of the value of n on the horizontal and the estimate of the temperature at the center of the plate on the vertical. b. using the value of n (or larger) that resulted in convergence in part (a), create a contourf plot of the temperature distribution across the entire plate. use enough spatial subdivisions to create a useful plot. comment on the results. hint: you need to determine what “x” and “y” values to use to make your t matrix. i recommend using a different number of x and y values. use enough x and y values so that the plot is “smooth”.