Physics, 24.04.2021 02:30 squirt3747

Recall your experimental setup from Lab 05A: a constant force was applied to a disc by attaching a mass to a light string wrapped around a mass-less pulley and hanging the mass over the edge of the apparatus. In the lab, you used energy conservation arguments to derive an expression for the angular velocity of the disc after the mass had fallen a distance x . Your goal now is to use kinematics and dynamics to confirm your expression. Use the following symbols throughout this question: m is the mass of the hanging mass, M is the mass of the disc, r is the radius of the pulley, R is the radius of the disc, x is the distance the mass has fallen, and g is the acceleration due to gravity. What is the linear acceleration of the mass after it has fallen a distance x

Answers: 2

Show answers

Another question on Physics

Physics, 22.06.2019 18:30

Aheavy piece of hanging sculpture is suspended by a90-cm-long, 5.0 g steel wire. when the wind blows hard, the wire hums at its fundamental frequency of 80hz. what is the mass of the sculpture?

Answers: 3

Answer

Physics, 22.06.2019 19:30

Scientist have use computer models to create a series of maps that show how susceptible coastal cities in island countries are to the sea rising at different levels.the map shows that a 1 meter rise would swap cities all along the us eastern seaboard. a 6-meter sea level rise with sub merge a large part of florida. thermal expansion has already raise the oceans 10 to 20 centimeters the most likely cause,directly and indirectly, for such a rise in sea level is

Answers: 2

Answer

Physics, 23.06.2019 01:30

The first law of thermodynamics is as follows: ∆u=q-w , which means in a system is equal to added, minus done by the system. the units for these variables are in .

Answers: 1

Answer

Physics, 23.06.2019 04:31

Suppose you hit your hand against the edge of table. using newton’s third law of motion why does my hand hurt? explain

Answers: 2

Answer

You know the right answer?

Recall your experimental setup from Lab 05A: a constant force was applied to a disc by attaching a m...

Questions