The diagram shows a lever. A weight is near the end of the lever. A force, F, pushes up on the pad and balances the lever.
(a)
The 50 N weight is pulling the lever anticlockwise around the pivot.
Calculate the moment (turning effect) of the 50 N weight about the pivot.
Give the units

Is it possible to use the energy from two atoms colliding to create a clean burning lasting fuel source with a large amount of force? is it also possible to harness that energy from the two atoms colliding to create a clean energy source that will last for years from just two atoms colliding. is there a possibility to control and store that energy for years but slowly let the energy out enough to power cities cheaper and faster.

Which type of microscope would allow the viewer to see ribosomes inside a cell?

Fft review: linspace, fs, fftshift, nfft 1. generate one second of a cosine of w,-10hz sampled at f, = 100hz and assign it to x. define a tt as your time axis 2. take 64 points fft. 3. as you remember, the dft (which the fft implements) computes n samples of s2t where k-0,1,2, n -1. plot the magnitude of this 64-points fft at range 0 to 63, what do you think of this graph? 4â·to get the x-axis into a hz-frequency form, plot this 64-points fft between-50 to 50 (the 100hz sampling rate) and have n-points between them. 5. according to your figure, what frequency is this cosine wave at? 6. remember that the fft is evaluating from 0 to 2ď€. we are used to viewing graphs from-ď€ to ď€. therefore, you need to shift your graph. 7. now according to your shifted graph. what frequency is this at? 8. note that the spikes have long drop-offs? try a 1024-point dft. note that the peak is closer to 10 and the drop-off is quicker. although, now sidelobes are an issue