Lines with irregular meter and length are called

The metric unit of electrical power is the watt volt ampere ohm

The integral design hub incorporates thento the bearing unit. n a. cv joint n b. mounting carrier n c. brake rotor n d tie rod end

Total solidification times of three casting geometries are to be compared: a sphere, a cylinder, in which the length-to-diameter ration - 1.0, and a cube. volume = 1000 cm^3 for all three shhapes, and the same casting alloy is used. a) determine the solidification times of each geometry b) based on the results of part (a), which geometric element would make the best riser? c) if the mold constant = 3.5 min/cm^2 in chvorinov's rule, compute the total solidification time for each casting.