Physics, 03.11.2019 09:31 lovelarissa

How are some types of collisions different from others?

Answers: 3

Show answers

Another question on Physics

Physics, 22.06.2019 05:10

Total solidification times of three casting geometries are to be compared: a sphere, a cylinder, in which the length-to-diameter ration - 1.0, and a cube. volume = 1000 cm^3 for all three shhapes, and the same casting alloy is used. a) determine the solidification times of each geometry b) based on the results of part (a), which geometric element would make the best riser? c) if the mold constant = 3.5 min/cm^2 in chvorinov's rule, compute the total solidification time for each casting.

Answers: 3

Answer

Physics, 22.06.2019 16:00

The process of predicting values that extend beyond the range of data points is called absolute value extrapolation interpolation prediction for any given: )

Answers: 2

Answer

Physics, 23.06.2019 06:30

Takumi works in his yard for 45 minutes each saturday. he works in the morning, and he wears sunscreen and a hat each time he works in the yard. what does takumi hope to reduce through his actions? the likelihood of stochastic effects, such as dna mutations the severity of stochastic effects, such as cancer the severity of non-stochastic effects, such as cancer the likelihood of non-stochastic effects, such as radiation sickness

Answers: 3

Answer

Physics, 23.06.2019 07:00

Conventional hot-water heaters consist of a tank of water maintained at a fixed temperature. the hot water is to be used when needed. the drawback is that energy is wasted because the tank loses heat when it is not in use, and you can run out of hot water if you use too much. some utility companies are encouraging the use of on-demand water heaters (also known as flash heaters), which consist of heating units to heat the water as you use it. no water tank is involved, so no heat is wasted. a typical household shower flow rate is 2.50 gal/min (9.46 l/min ) with the tap water being heated from 51.0 ˚f (10.6 ˚c) to 120 ˚f (48.9 ˚c) by the on-demand heater.what rate of heat input (either electrical of from gas) is required to operate such a unit, assuming that all the heat goes into the water?