Is there is only one tool used to heat equipment in the laboratory.

Aroll in a paper machine is powered by a separately excited dc machine. operating point 1 (under load): the roll typically operates at 764 rpm and must provide 301 nm of torque to oppose the load of the paper. the armature voltage is 230v for this operating point operating point 2 (no load): when the load is removed the speed of the roll increases to 900 rpm (the field characteristics are unchanged) la ea dev m (a) calculate the maximum torque (units of nm) that the motor can supply with this applied voltage (b) calculate the value of the armature resistance, ra (in ohms) (c) at operating point 1 (loaded condition), the field current, i, and the total input power (armature field), are measured to be to be 10 a and 28,600 w respectively. use this information to calculate the value of the field resistance, rf (in ohms). (d) (d) at operating point 1 (loaded condition), calculate the motor efficiency. express your answer as a percent to at least 2 significant digits. (d) if the field voltage is reduced by 1/2, calculate the new stall torque (in nm) of the motor (f). if the field voltage is reduced by 1/2, calculate the new no-load speed (in rad/sec)

An incident ray through the focal point of a spherical mirror will: reflect through the center of curvature. reflect back through the focal point. reflect parallel to the principle axis. reflect the same direction as the incident ray.

The 10-kg double wheel with radius of gyration of 125mm about o is connected to the spring of stiffness k = 600 n/m by a cord which is wrapped securely around the inner hub. if the wheel is released from rest on the incline with the spring stretched 225 mm, calculate the maximum velocity v of its center o during the ensuing motion. the wheel rolls without slipping