Physics, 08.04.2021 06:40 milkshakegrande101

A car engine burns gas at 495 K, and exhausts to the air at 293 K. If
it ran at the highest possible
efficiency and used 10,000 J of
input heat, how much heat would
be rejected into the air?
(Unit = J)

Answers: 1

Show answers

Another question on Physics

Physics, 21.06.2019 23:30

Acoil formed by wrapping 80 turns of wire in the shape of a square is positioned in a magnetic field so that the normal to the plane of the coil makes an angle of 28.0° with the direction of the field. when the magnetic field is increased uniformly from 200 µt to 600 µt in 0.400 as, an emf of magnitude 80.0 mv is induced in the coil. what is the total length of the wire?

Answers: 3

Answer

Physics, 22.06.2019 03:50

A30 kg weight lies on top of a massless piston of area a = 0.01 m2 the exterior air is at a (constant) p =1 atm and t = 27 c. the interior gas is 0.4 moles of (ideal) n2 and it has initial temperature 27.00 degrees c. 1. what is the initial pressure in the interior? a. 29.4 kpa b. 130.7 kpa c. 101.3 kpa the next three questions concern what happens when an amount of heat q is slowly added to the interior, raising the piston by 1 mm and raising the interior temperature to 27.40 c

Answers: 3

Answer

Physics, 22.06.2019 07:50

Calculate the ratio of h+ ions to oh– ions at a ph = 6. find the concentration of h+ ions to oh– ions listed in table b of your student guide. then divide the h+ concentration by the oh– concentration. record this calculated ratio in table a of your student guide. compare your approximated and calculated ratios of h+ ions to oh– ions at a ph = 6. are they the same? why or why not? record your explanation in table a. what is the concentration of h+ ions at a ph = 6? mol/l what is the concentration of oh– ions at a ph = 6? mol/l what is the ratio of h+ ions to oh– ions at a ph = 6? : 1

Answers: 1

Answer

Physics, 22.06.2019 11:20

The ultracentrifuge is an important tool for separating and analyzing proteins. because of the enormous centripetal accelerations, the centrifuge must be carefully balanced, with each sample matched by a sample of identical mass on the opposite side. any difference in the masses of opposing samples creates a net force on the shaft of the rotor, potentially leading to a catastrophic failure of the apparatus. suppose a scientist makes a slight error in sample preparation and one sample has a mass 10 mg larger than the opposing sample. if the samples are 12 cm from the axis of the rotor and the ultracentrifuge spins at 70,000 rpm, what is the magnitude of the net force on the rotor due to the unbalanced samples? ( be thorough on your answer)

Answers: 3

Answer

You know the right answer?

A car engine burns gas at 495 K, and exhausts to the air at 293 K. If
it ran at the highest p...

Questions