subject
Physics, 06.04.2021 07:00 Joshuafranklindude

Consider two cases m which the same ball is thrown against a wall with the same initial velocity. In case A, the ball sticks to the wall and does not bounce. In case B, the ball bounces back with the same speed that it came in with. Required:
a. In which of these two cases is the change in momentum the largest?
b. Assuming that the time during which the momentum change takes place is approximately the same for these two cases, in which case is the larger average force involved?
c. Is momentum conserved in this collision? Explain.

ansver
Answers: 2

Another question on Physics

question
Physics, 22.06.2019 10:00
Abookcase has a mass of 38 kg and the coefficient of friction between it and the floor is 0.82 what is the maximum force of friction between the bookcase and the floor a 372n b 305n c 412n d 449n
Answers: 1
question
Physics, 22.06.2019 23:30
Four 5-gram blocks of metal are sitting out in the sun and absorb the same amount of heat energy. use the following specific heat capacity data to determine which block will increase its temperature the most.
Answers: 2
question
Physics, 23.06.2019 02:10
Find the steady-state temperature at the center of the plate = /2, = /2) for sums of w from n=1 to n=19 (only odd values). find the value of n for which the change in /2, /2) is less than 1% from the value at the previous n. at this point, we consider the solution converged. does the value of the temperature at the center seem reasonable? in this part, the values of x and y are constant scalar values. you should produce a plot of the value of n on the horizontal and the estimate of the temperature at the center of the plate on the vertical. b. using the value of n (or larger) that resulted in convergence in part (a), create a contourf plot of the temperature distribution across the entire plate. use enough spatial subdivisions to create a useful plot. comment on the results. hint: you need to determine what “x” and “y” values to use to make your t matrix. i recommend using a different number of x and y values. use enough x and y values so that the plot is “smooth”.
Answers: 1
question
Physics, 23.06.2019 03:00
Use the library or internet to research each planet. make a chart comparing the following: approximate surface temperature relative surface gravity compared to earth atmospheric gases water in any form: solid, gas, or liquid when you have completed your chart, use the information you have collected to answer the following questions: which is the hottest planet? which is the coldest planet? which planet's temperature is closest to that of earth? (note: water boils at 100°c/212°f. water freezes at 0°c/32°f) which planet has the greatest gravitational attraction? which planet has the least gravitational attraction? which planet's gravitational pull is closest to that of earth? do any of the planets have oxygen in their atmosphere? which planet's atmosphere most resembles that of earth? do any of the planets have flowing water? which planet's water resources (solid, gas, or liquid) might be close to the amount on earth? which planet most resembles earth in terms of all of the factors: temperature, gravity, atmosphere, and water? if earth became an uninhabitable planet, which planet do you think would be the next best to live on? explain your answer.
Answers: 2
You know the right answer?
Consider two cases m which the same ball is thrown against a wall with the same initial velocity. In...
Questions
question
Chemistry, 02.05.2021 15:20
question
Mathematics, 02.05.2021 15:20
question
Mathematics, 02.05.2021 15:20
question
Physics, 02.05.2021 15:20
question
Mathematics, 02.05.2021 15:20
question
Mathematics, 02.05.2021 15:20
Questions on the website: 13722367