subject
Physics, 05.04.2021 17:00 kierafisher05

The diagram below shows a light ray striking Medium A and Medium B at the same angle. A rectangle labeled Medium A is drawn on the left. A ray of light travels through air and strikes the surface of medium A making an angle of 50 degrees with the vertical. The light ray bends towards the vertical as it travels through Medium A and makes an angle of about 15 degrees with the vertical. A rectangle labeled Medium B is drawn on the right. A ray of light travels through air and strikes the surface of medium B making an angle of 50 degrees with the vertical. The light ray bends towards the vertical as it travels through Medium B and makes an angle of about 25 degrees with the vertical.
Which statement is correct?

The speed of the light ray is the same in air and in Medium A.
The speed of the light ray is the same in air and in Medium B.
Medium A is denser than Medium B because light bends more in Medium A.
Medium B is denser than Medium A because light bends more in Medium B.

ansver
Answers: 3

Another question on Physics

question
Physics, 21.06.2019 20:40
In a steady-flow steam power plant system, two adiabatic high-pressure and low-pressure turbines ane used to generate power. superheated steam enters the high-pressure turbine at 8 mpa and 550°c. the steam expands in the high-pressure turbine to a saturated vapor at 3 mpa. in order to increase the powe generation of the power plant, another steam turbine working in a lower pressure ranges is deployed. the outlet vapor from the first turbine is heated up at a boiler to the temperature of 500 c at the constant pressure of first turbine's outlet (3 mpa). then, the vapor enters the second turbine and produces extra work. the exit conditions of the second turbine are 5o kpa and 90 percent quality. if the total power output of the power plant is 25 mw, determine a) the mass flow rate of the water (kg/s). b) heat transfer rate in the boiler (mw). (30 points) 3 mpa 00 c 8 mpa s0 c high pres turbine low pres boiler turbine 50 kpa 3 mpa 09 saturated vapor t heat engine, shown in the figure, operates between high temperature and low temperature of through a heat 4. a carnot tn and tu respectively. this heat engine receives energy from a heat reservoir at t exchanger where the heat transferred is proportional to the temperature difference as ? = k (z,-7, ). it rejects heat at a given low temperature tl. to design the heat engine for maximum work output, find the high temperature, th, as a function of tes and t. (15 points) qe
Answers: 3
question
Physics, 22.06.2019 09:00
Yvette hangs a 2.4kg bird feeder in the middle of a rope tied between two trees. the feeder creates a tension of 480 n in each side of the the rope.
Answers: 1
question
Physics, 22.06.2019 13:50
Two students, each riding bicycles, start from the same apartment building and ride to the same building on campus, but each takes a different route. the first student rides 1100 m due east and then turns due north and travels another 1430 m before arriving at the destination. the second student heads due north for 1930 m and then turns and heads directly toward the destination.at the turning point, how far is the second student from the destination?
Answers: 3
question
Physics, 22.06.2019 23:30
Four 5-gram blocks of metal are sitting out in the sun and absorb the same amount of heat energy. use the following specific heat capacity data to determine which block will increase its temperature the most.
Answers: 2
You know the right answer?
The diagram below shows a light ray striking Medium A and Medium B at the same angle. A rectangle l...
Questions
question
Mathematics, 24.02.2021 03:50
question
Mathematics, 24.02.2021 03:50
question
Mathematics, 24.02.2021 03:50
Questions on the website: 13722367