Physics, 01.04.2021 02:30 Valrom

Three concurrent forces are applied to keep a 150N weight in equilibrium. Two of the forces are given by F1= (-3i-25j+16k)N
F2 = (14i+16j+88k).
Assuming that the force of gravity is along the z-axis, determine the components of the third force.

Answers: 2

Show answers

Another question on Physics

Physics, 21.06.2019 18:00

Aplane flies directly between two cities, a and b, which are separated by . from a to b, the plane flies into a headwind. on the return trip from b to a, the wind velocity is unchanged. the trip from b to a takes less than the trip from a to b. what is the airspeed of the plane, assuming it is the same in both directions

Answers: 1

Answer

Physics, 22.06.2019 03:40

Aprojectile is launched from ground level with an initial velocity of v 0 feet per second. neglecting air resistance, its height in feet t seconds after launch is given by s equals negative 16 t squared plus v 0 t. find the time(s) that the projectile will (a) reach a height of 192 ft and (b) return to the ground when v 0equals112 feet per second. (a) find the time(s) that the projectile will reach a height of 192 ft when v 0equals112 feet per second. select the correct choice below and, if necessary, fill in the answer box to complete your choice.

Answers: 1

Answer

Physics, 22.06.2019 11:30

Arocket starts from rest and moves upward from the surface of the earth. for the first 10.0 s of its motion, the vertical acceleration of the rocket is given by ay = 12.80 m/s32t, where the +y-direction is upward. (a) what is the height of the rocket above the surface of the earth at t = 10.0 s? b) what is the speed of the rocket when it is 325 m above the surface of the earth?

Answers: 3

Answer

Physics, 22.06.2019 12:30

Brades exam guidelines exam instructions billing & payments & support question 6 of 20 : select the best answer for the question use this illustration to answer the question below. forms & resources al programs 9 ww linics 6. in the circuit shown in the figure above, suppose that the value of r, is 100k, and the value of r2 is 470 kq. at which of the following locations in the circuit would you measure the highest voltage with your meter? rvices 999999 a. between points b and c b. between points a and b c. between points b and e d. between points a and c eredu mark for review (will be highlighted on the review page) mend < < previous question next question

Answers: 1

Answer

You know the right answer?

Three concurrent forces are applied to keep a 150N weight in equilibrium. Two of the forces are give...

Questions