In practice, there may be a systematic error in this experiment because of Page 14 of 51
THE E
friction in the pulleys.
When the measurements were taken, increasing values of m were used. State
and explain how friction in the pulleys would have affected the measured
values of y.
(2)
(Total 13 marks)
P!​

Identical marbles are released from the same height on each of the following four frictionless ramps . compare the speed of the marbles at the end of each ramp. explain your reasoning

Abeam of electrons with of wavelength of 7.5 x 10-6 m is incident on a pair of narrow rectangular slits separated by 0.75 mm. the resulting interference pattern is projected onto a screen 10.0 m from the slits. what is the separation of the interference maxima in the resulting interference pattern?

Chapter 23, problem 075 the figure shows a geiger counter, a device used to detect ionizing radiation (radiation that causes ionization of atoms). the counter consists of a thin, positively charged central wire surrounded by a concentric, circular, conducting cylindrical shell with an equal negative charge. thus, a strong radial electric field is set up inside the shell. the shell contains a low-pressure inert gas. a particle of radiation entering the device through the shell wall ionizes a few of the gas atoms. the resulting free electrons (e) are drawn to the positive wire. however, the electric field is so intense that, between collisions with gas atoms, the free electrons gain energy sufficient to ionize these atoms also. more free electrons are thereby created, and the process is repeated until the electrons reach the wire. the resulting "avalanche" of electrons is collected by the wire, generating a signal that is used to record the passage of the original particle of radiation. suppose the radius of the central wire is 24 âµm, the inner radius of the shell 2.3 cm, and the length of the shell 14 cm. if the electric field at the shell's inner wall is 2.8 ă— 104 n/c, what is the total positive charge on the central wire?