Heat Conduction Through an Annular Wall With Temperature Dependent Conductivity Heat is flowing through an annular wall of inside radius ro and temperature To and outside radius r1 with temperature T1. (see next page) The thermal conductivity k(T) varies linearly with temperature through this region, (a) Obtain an expression for the total heat flow through the wall evaluated at the outer surface. (b) Simplify the above result when (d is the annular thickness, much smaller than the inner radius) in which case and the geometry unravels

Ablock of mass m = 2.5 kg is attached to a spring with spring constant k = 790 n/m. it is initially at rest on an inclined plane that is at an angle of 28 degrees with respect to the horizontal, and the coefficient of kinetic friction between the block and the plane is k = 0.14. in the initial position, where the spring is compressed by a distance of a = 0.18 m, the mass is at its lowest position and the spring is compressed the maximum amount. take the initial gravitational energy of the block as zero. b) if the spring pushes the block up the incline, what distance, l, in meters will the block travel before coming to rest? the spring remains attached to both the block and the fixed wall throughout its motion.

Two technicians are discussing a resistance measurement between the can-h and can-l wires. technician a says this measurement should be done with the ignition switch in the "run" position. technician b states that a measurement of 0 ohms indicates an open in the network. which technician is correct?

The speed of sound in ice, water, and steam is shown. what best explains the speed of sound in different states of matter? sound travels fastest in ice because energy is easier to transfer when the molecules are close together. sound travels slowest in steam because the sound has to move around the gas molecules that are far apart. sound travels fastest in ice because the temperature of solids is always greater, so the heat transfers the sound energy. sound travels slowest in steam because the pressure is so great the sound cannot travel though the steam particles.