subject
Physics, 01.03.2021 22:00 dorothylankford3823

A force of 50 N acts on the block at the angle shown in the diagram. The block moves a horizontal distance of 3.0 m. How much work is done by the applied force? a
150.0 Joules
b
75.0Joules
c
43.3 Joules
d
129.9 Joules

ansver
Answers: 2

Another question on Physics

question
Physics, 21.06.2019 16:30
As , plants meet their needs for making food from air, soil, water, and the sun's energy in a process called there are plants called grow high in trees without here are words to put in the blanks. 1.) producers 2.) consumers 3.) chloroplasts 4.) epiphytes
Answers: 3
question
Physics, 21.06.2019 19:40
You carry a 7.0-kg bag of groceries 1.2 m above the ground at constant speed across a 2.7m room. how much work do you do on the bag in the process? (a) 157j (b) 0.00j (c) 185j (d) 82j
Answers: 2
question
Physics, 21.06.2019 22:50
Two horizontal plates with infinite length and width are separated by a distance h in the z direction. the bottom plate is moving at a velocity u. the incompressible fluid trapped between the plates is moving in the positive x-direction with the bottom plate. align gravity with positive z. assume that the flow is fully-developed and laminar. if the systems operates at steady state and the pressure gradient in x-direction can be ignored, do the following: 1. sketch your system 2. identify the coordinate system to be used. 3. show your coordinates and origin point on the sketch. list all your assumptions. 5. apply the continuity equation to your system. nts of navier stokes equations of choice to your system 7. solve the resulting differential equation to obtain the velocity profile within the system make sure to list your boundary conditions. check units of velocity 8. describe the velocity profile you obtain using engineering terminology. sketch that on the same sketch you provided in (1). 9. obtain the equation that describes the volumetric flow rate in the system. check the units.
Answers: 2
question
Physics, 22.06.2019 04:50
Two technicians are discussing a resistance measurement between the can-h and can-l wires. technician a says this measurement should be done with the ignition switch in the "run" position. technician b states that a measurement of 0 ohms indicates an open in the network. which technician is correct?
Answers: 1
You know the right answer?
A force of 50 N acts on the block at the angle shown in the diagram. The block moves a horizontal di...
Questions
question
Mathematics, 25.07.2019 20:10
Questions on the website: 13722362