Physics, 25.02.2021 18:20 beebeck6573

The ball and chain most likely is connected to what type of simple machine at the top of the chain ?

Answers: 1

Show answers

Answers

Answer from: Quest

5 w for 1hr = 5x60x60 joules=300x60=3000x6=18,000j as total energy conversion. efficiency of bulb needed for radiant to thermal within 18000

Answer from: Quest

Iwould say a is accurate

Answer from: Quest

as we probably am aware that our atmosphere or air have various levels, each level has different gasses, and each gas has another porousness. at the point when the light originates from lower porousness to higher penetrability, it alters its course. with the goal that implies that when the light originates from the moon to the earth, it alters it's course a lot more occasions. it essentially implies that the state of the light piece of the moon is changed on the earth.

not copied too! hope this !

joke:

h o h o hope you have a merry christmas!

Answer from: Quest

force is based upon mass and acceleration.the statement is not always true.

it can be explained from newton's second law of motion.

as per newton's second law of motion the rate of change of momentum is directly proportional to the applied force and takes place along the direction of force.

mathematically it can be written as -

$f\alpha \frac{dp}{dt}$

⇒ $f= k \frac{dp}{dt}$

here k is the proportionality constant whose value is 1.

$f=\frac{dp}{dt}$

$f= \frac{d[mv]}{dt}$

$f= m\frac{dv}{dt} +v\frac{dm}{dt}$

$f=ma+v\frac{dm}{dt}$ [a is the acceleration=dv/dt]

hence we see that force not only depends on mass and acceleration but also on velocity and rate of change of mass. force f will depend on mass and acceleration only when mass is constant.

hence the statement that force is based upon mass and acceleration is false.

Another question on Physics

Physics, 22.06.2019 01:30

For problems 1-3, consider a simple dc brush motor with a permanent magnet stator. with an an consider a simple dc brush motor with a permanent magnet ae supply voltage of 100 v, the no-load speed of the motor is 1000 rpm. this motor can provide a torque of 1.9 n-m at 800 rpm drawing a current of 2 a current are both zero at no load.) 1. with an armature supply voltage of 100 v, the motor is operated at 900 rpm. what is the motor torque? what is the mechanical power delivered by the motor? what is the current draw? what is the electrical power input? what is the energy efficiency of the motor? with an armature supply voltage of 100 v, the motor is operated at 1100 rpm (where it acts as a generator). what torque input is required? what mechanical power is required what current is generated? what is the electrical power generated? what is the energy efficiency of the motor acting as a generator? 2. with an armature supply voltage raised to 120 v, the motor is operated at 1000 rpm. what is the no-load speed? what is the motor torque? what is the mechanical power delivered by the motor? what is the current draw? what is the electrical power input what is the energy efficiency of the motor? 3.

Answers: 3

Answer

Physics, 22.06.2019 04:00

However, had it been a real sound, the sound's pitch would have been increased by the doppler effect, since the falcon was moving the source of the sound. perpendicular to away from towards at the same speed as

Answers: 1

Answer

Physics, 22.06.2019 16:00

What part of the ear is names after tools, such as the hammer and the anvil?

Answers: 1

Answer

Physics, 22.06.2019 18:00

Which statement is true if the refractive index of medium a is greater than that of medium b? a. total internal reflection is possible when light travels from air to medium b to medium a. b. total internal reflection is possible when light travels from medium a to medium b. c. total internal reflection is possible when light travels from medium b to medium a. d. total internal reflection is possible when light travels from air to medium a. e. total internal reflection is possible when light travels from air to medium b.