TRUE OR FALSE 1. TRUE OR FALSE: The higher the frequency, the closer the waves are together and the LOWER the energy carried by the waves will be.
2. TRUE OR FALSE: The greater the force that produces a wave, the greater the amplitude of the wave and the greater the energy carried by the wave.
3. TRUE OR FALSE: In a transverse wave the higher the wave, the LOWER the amplitude
4. Wavelength is a measure of the distance from the crest on one wave to the crest on the very next wave.
5. TRUE OR FALSE: Speed is a measure of the distance a wave travels in an amount of time
6. TRUE OR FALSE: As a wave enters a different medium, the wave’s speed changes. Waves travel at different speeds in different media
7. TRUE OR FALSE: The highest point of a transverse wave is the crest and the lowest point is called a trough.

Explanation:

true true fauls true fauls fauls

with 5 seconds, no, but over time if the police car stays at 65m/s ad the speeding car stays at 60, then obviously yes, but the answer to your question would be, no.

hope this : )

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).