Physics, 18.02.2021 19:40 hamadehassan

A block that is connected to a horizontal spring is allowed to oncillate, and a graph of te velocity as a function of time is shown in the figure. At = 7 s, the block detaches from the spring. All frictional forces are considered to be negligible. What distance will the block travel from t = 7 tot 10 s?
a.0.0 m
b.1.5 m
c.3.0 m
d10.0 m

A block that is connected to a horizontal spring is allowed to oncillate, and a graph of te velocit

Answers: 3

Show answers

Another question on Physics

Physics, 22.06.2019 01:30

Question 7 [2 marks] in the circuit below, the electromotive force generated by the battery is e = 6.0 v, and the resistances are r1 = r4 = 1.0 q, r2 = r3 =2.0 q. r. the power delivered by the battery to the circuit is closest to a. 6 w в. 12 w с. 15 w d. 18 w e. 20 w final exam autumn 2014 page 5 of 9 68037 physical modelling faculty of science [2 mark] question 8 with reference to question 7, the current through resistor r2 is closest to a. 1 a в. 2 а c. 3 a d. 4 a e. 6 a

Answers: 2

Answer

Physics, 22.06.2019 04:30

You are traveling in a car going at a constant speed of 100km/h down a long, straight highway. you pass another car going in the same direction which is traveling at a constant speed of 80km/h. as measured from your car's reference frame this other car is traveling at −20km/h. what is the acceleration of your car as measured from the other car's reference frame? what is the acceleration of the other car as measured from your car's reference frame?

Answers: 2

Answer

Physics, 22.06.2019 05:50

There are two routes similar in terrain; however, one route has an incline of approximately 28 degrees, and you must decide on which route to take. what is the maximum road grade that your fully loaded ecv can climb?

Answers: 2

Answer

Physics, 22.06.2019 15:20

Acarpenter builds an exterior house wall with a layer of wood 2.9 cm thick on the outside and a layer of styrofoam insulation 2.3 cm thick on the inside wall surface. the wood has k=0.080w/(m⋅k), and the styrofoam has k= 0.010 w/(m⋅k). the interior surface temperature is 19.0 ∘c , and the exterior surface temperature is -15.0 ∘c . a.)what is the temperature at the plane where the wood meets the styrofoam? celsius b.)what is the rate of heat flow per square meter through this wall? /m^2

Answers: 2

Answer

You know the right answer?

A block that is connected to a horizontal spring is allowed to oncillate, and a graph of te velocity...

Questions