Which of the following would reduce the
amount of friction on a surface

There are several ways to reduce friction: The use of bearing surfaces that are themselves sacrificial, such as low shear materials, of which lead/copper journal bearings are an example. Replace sliding friction with rolling element friction, such as with the use of rolling element bearings.

Explanation:

List three ways of reducing friction. Polishing the rough surface. Providing all bearings or wheels between the moving parts of a machine or vehicles reduce friction and allow smooth movement as rolling friction is less than sliding friction.

Have a nice day!

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).

you go to your settings preference and in the end youll see sth that says "i want to delete my acc" click on it and u'll acc will be deleted but u have to wait.