Consider an RC circuit with a 10 Ohm resistor and a 1 mF capacitor connected in series powered by a 120 Vrms ac source operating at 60 Hz. For the RC pair calculate the instantaneous power and average power. Also sketch the instantaneous power and indicate when power flows into the RC pair and when it flows out of the RC pair back into the voltage source. How much energy is absorbed by the RC pair each second and how much energy is returned each second back to the source

Part f - example: finding two forces (part i) two dimensional dynamics often involves solving for two unknown quantities in two separate equations describing the total force. the block in (figure 1) has a mass m=10kg and is being pulled by a force f on a table with coefficient of static friction îľs=0.3. four forces act on it: the applied force f (directed î¸=30â above the horizontal). the force of gravity fg=mg (directly down, where g=9.8m/s2). the normal force n (directly up). the force of static friction fs (directly left, opposing any potential motion). if we want to find the size of the force necessary to just barely overcome static friction (in which case fs=îľsn), we use the condition that the sum of the forces in both directions must be 0. using some basic trigonometry, we can write this condition out for the forces in both the horizontal and vertical directions, respectively, as: fcosî¸â’îľsn=0 fsinî¸+nâ’mg=0 in order to find the magnitude of force f, we have to solve a system of two equations with both f and the normal force n unknown. use the methods we have learned to find an expression for f in terms of m, g, î¸, and îľs (no n).

The least penetrating form of radiation is

Students in an introductory physics lab are performing an experiment with a parallel-plate capacitor made of two circular aluminum plates, each 11 cm in diameter, separated by 1.0 cm. how much charge can be added to each of the plates before a spark jumps between the two plates? for such flat electrodes, assume that value of 3×106n/c of the field causes a spark.