Physics, 01.02.2021 23:30 joeduf

A long copper bar of rectangular cross-section, whose width w is much greater than its thickness L, is maintained in contact with a heat sink at its lower surface, and the temperature throughout the bar is approximately equal to that of the sink, To. Suddenly, an electric current is passed through the bar and an airstream of temperature T is passed over the top surface, while the bottom surface continues to be maintained at To. Obtain the differential equation and the top surface boundary condition that could be solved to determine the temperature as a function of position and time in the bar.

Answers: 1

Show answers

Another question on Physics

Physics, 21.06.2019 16:30

In this experiment, you will use a track, a toy car, and some washers to explore newton’s first two laws of motion. you will make observations and collect data regarding the motion of these objects. in the space below, write a general scientific question that you will answer by doing this experiment.

Answers: 1

Answer

Physics, 22.06.2019 01:10

Asteam power plant operates on an ideal reheat rankine cycle between the pressure limits of 15 mpa and 10 kpa. the mass flow rate of steam through the cycle is 12 kg/s. steam enters both stages of the turbine at 500°c. if the moisture content of the steam at the exit of the low-pressure turbine is not to exceed 10 percent, determine (a) the pressure at which reheating takes place, (b) the total rate of heat input in the boiler, and (c) the thermal efficiency of the cycle. also, show the cycle on a t-s diagram with respect to the saturation lines. (2.15 mpa; 45.0 mw; 42.6%)

Answers: 3

Answer

Physics, 22.06.2019 04:00

What is the final velocity of the initial velocity of 25 and -50?

Answers: 2

Answer

Physics, 22.06.2019 06:40

Determine the change in width a, height b, thickness t when a plate is subjected to the uniform distributed load and is made of material having modulus of elasticity e=230 gpa and poisson's ratio ν=1/3. given : a=400 mm and b= 300 mm also the uniformly distributed load in downward y direction of plate is 2 mn/m and in the positive x direction is 3 mn/m and t=20 mm

Answers: 1

Answer

You know the right answer?

A long copper bar of rectangular cross-section, whose width w is much greater than its thickness L,...

Questions