subject
Physics, 27.01.2021 07:10 cheatcodeb

In the figure, a 16 000N wrecking ball is pulled back with a horizontal force of
7000w before being swung against the sic
ofā building. What angle does the
wrecking ball make with the vertical wher
it is pulled back?
F
7000 N
16,000N


In the figure, a 16 000N wrecking ball is

pulled back with a horizontal force of
7000w before bei

ansver
Answers: 1

Another question on Physics

question
Physics, 22.06.2019 01:10
Asteam power plant operates on an ideal reheat rankine cycle between the pressure limits of 15 mpa and 10 kpa. the mass flow rate of steam through the cycle is 12 kg/s. steam enters both stages of the turbine at 500°c. if the moisture content of the steam at the exit of the low-pressure turbine is not to exceed 10 percent, determine (a) the pressure at which reheating takes place, (b) the total rate of heat input in the boiler, and (c) the thermal efficiency of the cycle. also, show the cycle on a t-s diagram with respect to the saturation lines. (2.15 mpa; 45.0 mw; 42.6%)
Answers: 3
question
Physics, 22.06.2019 08:20
At an oceanside nuclear power plant, seawater is used as part of the cooling system. this raises the temperature of the water that is discharged back into the ocean. the amount that the water temperature is raised has a uniform distribution over the interval from 10° to 25° c. what is the standard deviation of the temperature increase?
Answers: 1
question
Physics, 22.06.2019 08:40
When temperature of a substance increases, of its particles increase resulting in more between particles. real world applications of thermal expansion absolute zero (-273 degrees c) is the lowest possible temperature on the kelvin scale. it is a measure of where a substance has no kinetic energy. heat is a process of the . energy flows spontaneously from a object to a until equilibrium is reached. heat is measured in heat is transferred throughis a method of heat transfer that occurs between particles of matter that are in direct contact with each other. are poor conductors that impede / reduce the rate of heat transfer. is a method of heat transfer that occurs in fluids (non-solids) by means of currents. real world application of convectiona method of heat transfer through electromagnetic waves. when energy moves from one object to another inside a closed system, no energy is or in the system in the transaction. systems will spontaneously move to a state of organized energy or high disorder over time called
Answers: 2
question
Physics, 22.06.2019 11:30
Two 1.20-m nonconducting wires meet at a right angle. one segment carries + 2.50 µc of charge distributed uniformly along its length, and the other carries - 2.50 µc distributed uniformly along it, as shown in fig. 21.50. ( a. find the magnitude and direction of the electric field these wires produce at point p, which is 60.0 cm from each wire. ( b. if an electron is released at p, what are the magnitude and direction of the net force that these wires exert on it?
Answers: 3
You know the right answer?
In the figure, a 16 000N wrecking ball is pulled back with a horizontal force of
7000w before...
Questions
Questions on the website: 13722360