subject
Physics, 21.01.2021 15:30 brookesquibbs

The work done on the machine is called

ansver
Answers: 1

Another question on Physics

question
Physics, 21.06.2019 23:30
Aknife blade is a(n) a. lever b. screw c. wedge d. inclined plane
Answers: 2
question
Physics, 22.06.2019 01:10
Asteam power plant operates on an ideal reheat rankine cycle between the pressure limits of 15 mpa and 10 kpa. the mass flow rate of steam through the cycle is 12 kg/s. steam enters both stages of the turbine at 500°c. if the moisture content of the steam at the exit of the low-pressure turbine is not to exceed 10 percent, determine (a) the pressure at which reheating takes place, (b) the total rate of heat input in the boiler, and (c) the thermal efficiency of the cycle. also, show the cycle on a t-s diagram with respect to the saturation lines. (2.15 mpa; 45.0 mw; 42.6%)
Answers: 3
question
Physics, 22.06.2019 08:30
What is the primary force that suspension bridges use cables to hold their spans up? a. tension force b. resistance force c. normal force d. elastic force e. applied force
Answers: 3
question
Physics, 22.06.2019 09:00
The pressure proportional to the area a- inversely b- directly c- increase d-decrease
Answers: 2
You know the right answer?
The work done on the machine is called...
Questions
question
Health, 24.06.2019 20:40
Questions on the website: 13722361