In a hydraulic lift, the radius of the small and large pistons are 2.50cm and 10.0cm respectively. A vehicle weighing 12.0kN is to be
lifted by the large piston. Calculate
a) the force that must be applied to the small piston
b) the distance that the small piston has to be pushed down to raise the vehicle a diatance of 2.00cm

Aroll in a paper machine is powered by a separately excited dc machine. operating point 1 (under load): the roll typically operates at 764 rpm and must provide 301 nm of torque to oppose the load of the paper. the armature voltage is 230v for this operating point operating point 2 (no load): when the load is removed the speed of the roll increases to 900 rpm (the field characteristics are unchanged) la ea dev m (a) calculate the maximum torque (units of nm) that the motor can supply with this applied voltage (b) calculate the value of the armature resistance, ra (in ohms) (c) at operating point 1 (loaded condition), the field current, i, and the total input power (armature field), are measured to be to be 10 a and 28,600 w respectively. use this information to calculate the value of the field resistance, rf (in ohms). (d) (d) at operating point 1 (loaded condition), calculate the motor efficiency. express your answer as a percent to at least 2 significant digits. (d) if the field voltage is reduced by 1/2, calculate the new stall torque (in nm) of the motor (f). if the field voltage is reduced by 1/2, calculate the new no-load speed (in rad/sec)

A2-kg bowling ball is 2.5 meters off the ground on a post when it falls. just before it reaches the ground, it is traveling 7 m/s. assuming that there is no air resistance, which statement is true?

In a good thermo flask the main cause of heat loss is