subject
Physics, 11.01.2021 21:30 allisonatalie6654

This question is a long free response question. Please show all work. I AM GIVING 3 TIMES THE POINTS FOR THIS QUESTION AND I WILL GIVE BRAINLIEST SO PLEASE RESPOND ASAP WITH GOOD ANSWERS.

A spring-loaded launcher can be securely attached to a tabletop. When the spring is at its uncompressed length, the plunger is in the position shown above in Figure 1. A small wood block can be pressed against the end of the plunger, compressing the spring a distance L , as shown in Figure 2. When the block is released, the plunger pushes the block along the tabletop. Two pins are attached to the edge of the table to prevent the plunger from extending beyond the table. When the plunger hits the pins, the block then leaves the table. There is nonnegligible friction between the block and the tabletop.

The launcher can be moved closer to or farther from the edge of the tabletop. Students set up tables 1 and 2, as shown above, with tabletops that are made of the same material. On table 1, the launcher is positioned so that the distance s=A between the launcher and the edge of the tabletop is slightly less than L. On table 2, the launcher is positioned so that the distance s=B between the launcher and the edge of the tabletop is significantly less than L. On both tables, the block is released from rest and loses contact with the plunger at the moment the plunger reaches the pins. Tables 1 and 2 are the same height.

k is the spring constant of the spring.
m is the mass of the block.
L is the distance the spring is compressed.
μ (mu) is the coefficient of kinetic friction between the block and the tabletop.
s is the distance between the launcher and the edge of the tabletop.

(a) Without manipulating equations, explain why the block launched from table 1 could land farther from the table than the block launched from table 2 does.

(b) Does the block launched from table 1 spend more, less, or the same amount of time in the air than the block launched from table 2 does? Explain your reasoning.

(c) Consider the Earth-block system. Determine the change, if any, in the total mechanical energy of the system from the instant the block leaves the table to the instant immediately before it reaches the ground.

The students correctly derive an equation for the horizontal distance D from the edge of the tabletop that the block lands, in terms of s (the distance between the launcher and the edge of the tabletop):

Note: the u in the above equation is actually a μ but the formula maker in doesn't like that.
where t is the time interval between the instant the block leaves the table and the instant immediately before it reaches the ground.

(d) Does this equation for D support your argument from part (a) that the block launched from table 1 could land farther from the table than the block launched from table 2? Briefly explain why or why not.

(e) The students now use the same setups to launch blocks that are identical to each other but more massive than the original blocks. The blocks are made of the same material as the original blocks. Does this change in the mass of the blocks make it more likely or less likely that the block launched from table 1 goes farther than the block launched from table 2 does? Briefly explain your reasoning.

(f) Two students each try to sketch a graph of the kinetic energy of the block as a function of its position from launch to the time the block reaches the edge of the table. Their graphs are shown above. Which graph best represents the kinetic energy of the block? Justify your selection.


D = t\sqrt{\frac{k}{m} * (2Ls - (s*s) - 2ugs }

ansver
Answers: 3

Another question on Physics

question
Physics, 22.06.2019 14:30
Which of these is constant for all types of electromagnetic radiation in a vacuum? select one: a. wavelength b. frequency c. photon energy d. amplitude e. velocity
Answers: 3
question
Physics, 22.06.2019 23:40
Along wire of diameter 1 mm is submerged in an oil bath of temperature ∞ 31°c. the wire has an electrical resistance per unit length of 0.01 ω/m. if a current of 103 a flows through the wire and the convection coefficient is 500 w/m2·k, what is the steady-state temperature of the wire? from the time the current is applied, how long does it take for the wire to reach a temperature that is within 1°c of the steady-state value? the properties of the wire are 8000 kg/m3, 500 j/kg·k, and 20 w/m·k.
Answers: 3
question
Physics, 23.06.2019 01:30
Which statements did both aristotle and ptolemy assume? check all that apply.
Answers: 1
question
Physics, 23.06.2019 05:30
20) what is a magnetic field? 21) in which direction do magnetic field lines always point? 22) sketch a diagram showing how a plotting compass points around a 23) name two magnetic poles that will: a) attract each other b) repel each other. 24) explain why you can use a compass to navigate. 25) what's an electromagnet? 26) list two ways to increase the strength of an electromagnet. 27) the wire in a simple motor feels a force when a current flows through it. why is this? i need answers to check mine
Answers: 1
You know the right answer?
This question is a long free response question. Please show all work. I AM GIVING 3 TIMES THE POINT...
Questions
question
Mathematics, 09.06.2021 19:00
question
Mathematics, 09.06.2021 19:00
question
Chemistry, 09.06.2021 19:00
question
Mathematics, 09.06.2021 19:00
question
Mathematics, 09.06.2021 19:00
Questions on the website: 13722363