subject
Physics, 07.01.2021 02:00 tina5513

When spotting an overhead press, the spotter would need to . A.
keep his or her hands off the lifter and weights and make sure the lifter did not fall back
B.
keep his or her hands beneath the bar and watch the bar carefully
C.
hold the lifter under his or her shoulders and move with the lifter as the weight is lifted
D.
place his or her hands outside the lifter's hands and stand with a straight back

ansver
Answers: 3

Another question on Physics

question
Physics, 22.06.2019 10:00
**urgent** roberto plans to use two transformers to reduce a voltage of 120 v to 4 v. he uses a transformer that has 300 coils in the primary winding and 50 coils in the secondary winding. he has four other transformers, as listed in the table. which transformer should roberto use to have an ending voltage of 4 v? a- w b-xc- yd- z
Answers: 1
question
Physics, 22.06.2019 21:30
Which of the following best describes the circuit shown below?
Answers: 3
question
Physics, 23.06.2019 02:00
Answer asap 50 points which of the following illustrates how a venus fly trap senses that an insect has landed in its open leaves? 1. using tiny hairs, the leaves sense a change in light. 2. using tiny hairs, the leaves taste a chemical. 3. using tiny hairs, the leaves detect a touch. 4. using tiny hairs, the leaves sense a change in water levels.
Answers: 1
question
Physics, 23.06.2019 02:40
Check the following equation for dimensional homogeneity: ⅆ mv=∫t1t2(f⁢cosθ)ⅆt where m is mass, v is velocity, f is force, θ is an angle, and t is time. check that each term in the equation has the following dimensions: [malbec] where you are to choose the coefficients a, b, c.
Answers: 2
You know the right answer?
When spotting an overhead press, the spotter would need to . A.
keep his or her hands off the...
Questions
question
Mathematics, 06.07.2019 16:00
question
Mathematics, 06.07.2019 16:00
Questions on the website: 13722367