A horse pulls a Wagon forward. what is the equal and opposite force for the force of the horse pushing down on the ground as described by newtons third law?

A. Grounds friction pushes forward on the horse’s hooves
B. Horses force of gravity pulls up on earth
C. Ground pushes up on the horses hooves
D. Earth’s force of gravity pulls down on the horse.

Ahorizontal wire is tied to supports at each end and vibrates in its second-overtone standing wave. the tension in the wire is 5.00 n, and the node-to-node distance in the standing wave is 6.28 cm. (a) what is the length of the wire? (b) a point at an anti- node of the standing wave on the wire travels from its maximum upward displacement to its maximum downward displacement in 8.40 ms. what is the wire's mass?

In a steady-flow steam power plant system, two adiabatic high-pressure and low-pressure turbines ane used to generate power. superheated steam enters the high-pressure turbine at 8 mpa and 550°c. the steam expands in the high-pressure turbine to a saturated vapor at 3 mpa. in order to increase the powe generation of the power plant, another steam turbine working in a lower pressure ranges is deployed. the outlet vapor from the first turbine is heated up at a boiler to the temperature of 500 c at the constant pressure of first turbine's outlet (3 mpa). then, the vapor enters the second turbine and produces extra work. the exit conditions of the second turbine are 5o kpa and 90 percent quality. if the total power output of the power plant is 25 mw, determine a) the mass flow rate of the water (kg/s). b) heat transfer rate in the boiler (mw). (30 points) 3 mpa 00 c 8 mpa s0 c high pres turbine low pres boiler turbine 50 kpa 3 mpa 09 saturated vapor t heat engine, shown in the figure, operates between high temperature and low temperature of through a heat 4. a carnot tn and tu respectively. this heat engine receives energy from a heat reservoir at t exchanger where the heat transferred is proportional to the temperature difference as ? = k (z,-7, ). it rejects heat at a given low temperature tl. to design the heat engine for maximum work output, find the high temperature, th, as a function of tes and t. (15 points) qe

**urgent** roberto plans to use two transformers to reduce a voltage of 120 v to 4 v. he uses a transformer that has 300 coils in the primary winding and 50 coils in the secondary winding. he has four other transformers, as listed in the table. which transformer should roberto use to have an ending voltage of 4 v? a- w b-xc- yd- z