subject
Physics, 17.12.2020 19:30 mcentire789

Which manufacturing process is shown in the photograph? A. Separating
B. Conditioning
C. Forming
D. Combining
SUR


Which manufacturing process is shown in the photograph?

A. Separating
B. Conditioning
C. Forming

ansver
Answers: 1

Another question on Physics

question
Physics, 22.06.2019 04:30
You are traveling in a car going at a constant speed of 100km/h down a long, straight highway. you pass another car going in the same direction which is traveling at a constant speed of 80km/h. as measured from your car's reference frame this other car is traveling at βˆ’20km/h. what is the acceleration of your car as measured from the other car's reference frame? what is the acceleration of the other car as measured from your car's reference frame?
Answers: 2
question
Physics, 22.06.2019 14:10
Your starship, the aimless wanderer, lands on the mysterious planet mongo. as chief scientist-engineer, you make the following measurements: a 2.50-kg stone thrown upward from the ground at 14.0 m/s returns to the ground in 5.70 s ; the circumference of mongo at the equator is 2.20Γ—10^5 km ; and there is no appreciable atmosphere on mongo. (a) the starship commander, captain confusion, asks for the following information: what is the mass of mongo? (b) if the aimless wanderer goes into a circular orbit 2.20Γ—10^4 km above the surface of mongo, how many hours will it take the ship to complete one orbit? (c) an unmanned spacecraft is in a circular orbit around the moon, observing the lunar surface from an altitude of 44.0 km . to the dismay of scientists on earth, an electrical fault causes an on-board thruster to fire, decreasing the speed of the spacecraft by 23.0 m/s . if nothing is done to correct its orbit, with what speed (in km/h) will the spacecraft crash into the lunar surface?
Answers: 1
question
Physics, 22.06.2019 22:00
It takes a lot of energy to get the temperature of water to increase and eventually boil because water has a high heat.
Answers: 1
question
Physics, 23.06.2019 02:20
If 130 j of energy were added to 1 kg of each of the samples listed in the answer choices, which would experience the greatest temperature increase
Answers: 2
You know the right answer?
Which manufacturing process is shown in the photograph? A. Separating
B. Conditioning
C...
Questions
question
Mathematics, 28.01.2020 02:31
question
Mathematics, 28.01.2020 02:31
Questions on the website: 13722359