subject
Physics, 10.12.2020 17:30 jdvazquez18p7a7vs

Activity B: Conservation of matterGet the Gizmo ready:Click Reset. Select Hydrogen peroxide for Reactant 1and Potassium iodidefor Reactant 2.Goal: How does the mass change(or not change)during a chemical reaction?1.Review: In this reaction, hydrogen peroxide is added to a potassium iodide solution. Click Playand observe the reaction. A.What do you observe? B. What evidence do you see that a chemical reaction is taking place? C. Replay the reaction and use the available tools (Thermometer, Phenol red, Glowing splint, Burningsplint.)What do these tools indicate?(Note: You will need to switch to the Gas collectionsetup to use the splint.)Thermometer: Phenol red: Glowing splint: Burning splint: 2.Record: Click Reset, and changebackto the Normal setup. Notice the mass shown on the electronic balance. A.What is the starting mass for this reaction? B. Click Play. What is the mass when the reaction has finished? C. How does the mass changein this reaction? 3.Record: Click Reset, and select the Gas collection setup. Notice that this setup is heavier than the normal setup, but the amounts of reactants is the same. A.What is the starting mass for this reaction? B. How do you think the mass will change during the reaction? C. Click Play. What is the mass when the reaction has finished? (Activity B continued on next page) 2018Activity B (continued from previous page)4.Explain:Why do you think that mass was lost when the reaction was done in the normal setup, but stayed the same when the reaction was done in the gas collection setup? A fundamental law of chemistry is conservation of matter. This law states that, in a chemical reaction, matter can neither be created nor destroyed. That means that, as long as nothing escapes from the system, the total mass measured at the start of the reaction will be the same as the total mass at the end of the reaction CORRECT ANSWERS WILL GET BRAINLIEST

ansver
Answers: 2

Another question on Physics

question
Physics, 21.06.2019 17:20
Explain why the aperture of the spherical mirror should be small compared to the radius of curvature of the mirror.
Answers: 1
question
Physics, 21.06.2019 21:10
Tafari worked one summer on a ship that set weather buoys in the ocean. he watched how one of the buoys moved in the water. describe which parts of the wave would cause the buoy to bob up and down. which wave property determined how fast the buoys bobbed in the water? he observed that when the wind blew harder, the ocean waves were larger, and the buoys moved away from the ship. what effect, if any, did the waves have on how far the buoys moved? explain your answer.
Answers: 3
question
Physics, 22.06.2019 00:20
Aparticle of mass m is projected with an initial velocity v0 in a direction making an angle α with the horizontal level ground as shown in the figure. the motion of the particle occurs under a uniform gravitational field g pointing downward. (a) write down the lagrangian of the system by using the cartesian coordinates (x, y). (b) is there any cyclic coordinate(s). if so, interpret it (them) physically. (c) find the euler-lagrange equations. find at least one constant of motion. (d) solve the differential equation in part (c) and obtain x and y coordinates of the projectile as a function of time. (e) construct the hamiltonian of the system, h, and write down the hamilton’s equations (canonical equations) of motion.
Answers: 2
question
Physics, 22.06.2019 03:30
As part of an industrial process, air as an ideal gas at 10 bar, 400k expands at steady state through a valve to a pressure of 4 bar. the mass flow rate of air is 0.5 kg/s. the air then passes through a heat exchanger where it is cooled to a temperature of 295k with negligible change in pressure. the valve can be modeled as a throttling process, and kinetic and potential energy effects can be neglected. (a) for a control volume enclosing the valve and heat exchanger and enough of the local surroundings that the heat transfer occurs at the ambient temperature of 295 k, determine the rate of entropy production, in kw/k. (b) if the expansion valve were replaced by an adiabatic turbine operating isentropically, what would be the entropy production? compare the results of parts (a) and (b) and discuss.
Answers: 3
You know the right answer?
Activity B: Conservation of matterGet the Gizmo ready:Click Reset. Select Hydrogen peroxide for Rea...
Questions
Questions on the website: 13722360