In your own words differentiate Comets Asteroids Meteors Meteoroids and Meteorites

Thanks for the question,

Asteroids: These are rocky and airless plates from the formation of planets in our solar system. It basically revolves around our sun in the space barrier between Mars and Jupiter and moves in the size of cars to smaller planets.

Comets: comets are the most polluted glaciers of ice and dust created at the time of the birth of the solar system 4.6 billion years ago. Many comets have a fixed orbit around the outer surface of the solar system beyond the planet Neptune.

Meteoroids, Meteorites, Meteorites: Meteoroids are small asteroids or broken comet fragments and sometimes planets. They vary in size from sand dune to three large stones in diameter. When meteoroids collide with the earth's atmosphere, they form meteors. When those meteors survive space and reach the surface of the planet, their remains are called meteorites.

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).

the body's situation won't change the forces are equal opposit and on the same body