A circular coil of wire, with N turns of radius a, is located in the field of an electromagnet. The magnetic field is perpendicular to the coil (that is, parallel to the axis of the coil) and its strength has the constant value B, over that area. The coil is connectd by a pari of twisted leads to an exteranl resistance. The toal resistance of this closed circuit, including that of the coil itself, is R. Suppose the electromagnet is turned off, its field dropping rapidly to zero. The induced electromotive force causes current to flow around the circuit. Derive a formula for the total charge Q = Sidt that passes through the resistor and explain why it does not depend on the rapidity with which the field drops to zero.

Which of the following changes to a pipe would increase the conductance by a factor of 12? 1.quadrupling the length and tripling the radius.2.reducing the length by a factor of and doubling the radius.3.tripling the length and reducing the radius by a factor of .4.reducing the length but a factor of and doubling the radius.

Asap 1. which surface feature of the moon is characterized by mountainous areas? question options: maria terrae regolith craters 2.which statement describes surface features called maria on the moon? question options: layers of dust and rock deep areas of cooled lava deep, rocky and barren valleys highlands and mountainous areas

Steam is generated in a boiler of a cogeneration plant at 10 mpa and 450°c at a steady rate of 5 kg/s. in normal operation, steam expands in a turbine to a pressure of 0.5 mpa and is then routed to the process heater, where it supplies the process heat. steam leaves the process heater as a saturated liquid and is pumped to the boiler pressure. in this mode, no steam passes through a condenser, which operates at 20 kpa. (a) determine the power produced in the turbine and the rate at which process heat is supplied in this mode. (b) determine the power produced in the turbine and the rate of process heat supplied if only 60 percent of the steam is routed to the process heater and the remainder is expanded to the condenser pressure. (3.32 mw; 9.69 mw; 4.25 mw; 5.82 mw)