9) Which statement is correct about the potential energy of a car moving down a ramp? -Potential energy depends on the mass and velocity of the car.
-Potential energy remains constant because total energy is constant.
-Potential energy is highest when the car is released at the top of the ramp.
-Potential energy is highest when the car reaches the bottom of the ramp

10)In a closed system of a cannon and cannonball, which changes would both result in an increase in the kinetic energy of the cannonball when fired from the cannon?(
increase the mass of the cannon or decrease the mass of the cannonball

increase the mass of the cannon or increase the mass of the cannonball

decrease the mass of the cannon or increase the mass of the cannonball

decrease the mass of the cannon or decrease the mass of the cannonball

c.is a substance that requires a small amount of energy per gram to raise its temperature; has strong cohesive forces between molecules.

explanation:

a colorless, transparent, odorless liquid that forms the seas, lakes, rivers, and rain and is the basis of the fluids of living organisms.

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).

+15-35=-20

going in opposite directions