A solenoid with 2,781 turns has a radius of 74.7 mm and is 38.4 cm long. If this solenoid carries a current of 68.4 A, what is the magnitude of the magnetic field near the center of the solenoid

Aroll in a paper machine is powered by a separately excited dc machine. operating point 1 (under load): the roll typically operates at 764 rpm and must provide 301 nm of torque to oppose the load of the paper. the armature voltage is 230v for this operating point operating point 2 (no load): when the load is removed the speed of the roll increases to 900 rpm (the field characteristics are unchanged) la ea dev m (a) calculate the maximum torque (units of nm) that the motor can supply with this applied voltage (b) calculate the value of the armature resistance, ra (in ohms) (c) at operating point 1 (loaded condition), the field current, i, and the total input power (armature field), are measured to be to be 10 a and 28,600 w respectively. use this information to calculate the value of the field resistance, rf (in ohms). (d) (d) at operating point 1 (loaded condition), calculate the motor efficiency. express your answer as a percent to at least 2 significant digits. (d) if the field voltage is reduced by 1/2, calculate the new stall torque (in nm) of the motor (f). if the field voltage is reduced by 1/2, calculate the new no-load speed (in rad/sec)

Aspecimen of oil having an initial volume of 580cm^3 is subjected to a pressure increase of 4.0 mpa, and the volume is found to decrease by 0.40 cm^3. (a) what is the bulk modulus of the material? (b) what is the compressibility of the material?

The a992 steel rod bc has a diameter of 50 mm and is used as a strut to support the beam. determine the maximum intensity w of the uniform distributed load that can be applied to the beam without risk of causing the strut to buckle. take f.s. = 2 against bucklin