What is the independent and dependent variable. After learning about electricity, a student wants to see if electricity flows better through different materials. Our wonderful student has different materials: copper wire, aluminum wire, carbon fiber, and gold wire. The student attaches a small lightbulb to a 9 volt battery, and uses each wire to see how bright the lightbulb lights up when connected to each material.

Aprojectile is launched horizontally 10m above the ground and with an initial velocity of 15 m/s. a) sketch the trajectory using an appropriate coordination system. b) how long for the projectile to reach the ground. c) how far did projectile travel horizontally before striking the ground. d) determine the projectilex & y position at t-1.3s e) determine the magnitude and direction of projectile velocity at t= 1.3s f) determine the magnitude and direction of projectile acceleration at t-1.3s

Which is not a characteristic of a heat pump? a. it is used in air conditioners. b. it uses a refrigerant. c. it requires no work. d. it reverses the normal flow of thermal energy.

Steam is generated in a boiler of a cogeneration plant at 10 mpa and 450°c at a steady rate of 5 kg/s. in normal operation, steam expands in a turbine to a pressure of 0.5 mpa and is then routed to the process heater, where it supplies the process heat. steam leaves the process heater as a saturated liquid and is pumped to the boiler pressure. in this mode, no steam passes through a condenser, which operates at 20 kpa. (a) determine the power produced in the turbine and the rate at which process heat is supplied in this mode. (b) determine the power produced in the turbine and the rate of process heat supplied if only 60 percent of the steam is routed to the process heater and the remainder is expanded to the condenser pressure. (3.32 mw; 9.69 mw; 4.25 mw; 5.82 mw)