Apply the general results obtained in the full analysis of motion under the influence of a constant force in Section 2.5 to answer the following questions. You hold a small metal ball of mass a height above the floor. You let go, and the ball falls to the floor. Choose the origin of the coordinate system to be on the floor where the ball hits, with up as usual. Express all results in terms of , , and . Just after release, what are and

Aroll in a paper machine is powered by a separately excited dc machine. operating point 1 (under load): the roll typically operates at 764 rpm and must provide 301 nm of torque to oppose the load of the paper. the armature voltage is 230v for this operating point operating point 2 (no load): when the load is removed the speed of the roll increases to 900 rpm (the field characteristics are unchanged) la ea dev m (a) calculate the maximum torque (units of nm) that the motor can supply with this applied voltage (b) calculate the value of the armature resistance, ra (in ohms) (c) at operating point 1 (loaded condition), the field current, i, and the total input power (armature field), are measured to be to be 10 a and 28,600 w respectively. use this information to calculate the value of the field resistance, rf (in ohms). (d) (d) at operating point 1 (loaded condition), calculate the motor efficiency. express your answer as a percent to at least 2 significant digits. (d) if the field voltage is reduced by 1/2, calculate the new stall torque (in nm) of the motor (f). if the field voltage is reduced by 1/2, calculate the new no-load speed (in rad/sec)

Asmall, positively charged ball is moved close to a large, positively charged ball. which describes how the small ball likely responds when it is released? it will move toward the large ball because like charges repel. it will move toward the large ball because like charges attract. it will move away from the large ball because like charges repel. it will move away from the large ball because like charges attract.

Examine the nuclear reacti why is this classified as a nuclear reaction rather than a chemical reaction? it is not balanced. a new compound is formed. a change has occurred in a nucleus. a new element has been formed.