subject
Physics, 08.10.2020 23:01 jackh0406

The arrows in the chart below represent phase transitions. Solid
3
Liquid
Gas
Which arrows represent the phase transitions in which heat energy is gained?
୦ 1, 2, and 3
2, 3, and 5
3, 4, and 5
O 4,5, and 6


The arrows in the chart below represent phase transitions.

Solid
3
Liquid
Gas
Which arrows repres

ansver
Answers: 2

Another question on Physics

question
Physics, 21.06.2019 14:50
Agalvanometer has an internal resistance of 100 ω and deflects full-scale at 2.00 ma. what size resistor should be added to the galvanometer to convert it to a milliammeter capable of reading up to 4.00 ma, and how should this resistor be connected to the galvanometer?
Answers: 2
question
Physics, 21.06.2019 16:30
Which statement best describes resistance? resistance is a. how well a current will flow in a material and is measured in volts. b. how well a material conducts an electrical charge and is measured in ohms. c. the ability of a material to attract a positive charge to create a current. d. the ability of a material to repel neutral charges and is measured in ohms.
Answers: 3
question
Physics, 22.06.2019 03:30
Using a wheel and axle, a farmer is trying to lift a bucket of water from the bottom of a well. the larger wheel has a radius of 40 cm compared to the axle that has a radius of 10 cm. if a bucket of water is 50 n, then how much effort is required to raise it? 12.5 n 200 n 2 n 500 n
Answers: 1
question
Physics, 22.06.2019 07:30
Some material consisting of a collection of microscopic objects is kept at a high temperature. a photon detector capable of detecting photon energies from infrared through ultraviolet observes photons emitted with energies of 0.3 ev, 0.5 ev, 0.8 ev, 2.0ev, 2.5ev, and 2.8ev. these are the only photon energies observed. (a) draw and label a possible energy-level diagram for one of the microscopic objects, which has four bound states. on the diagram, indicate the transitions corresponding to the emitted photons. explain briefly. (b) would a spring–mass model be a good model for these microscopic objects? why or why not? (c) the material is now cooled down to a very low temperature, and the photon detector stops detecting photon emissions. next, a beam of light with a continuous range of energies from infrared through ultraviolet shines on the material, and the photon detector observes the beam of light after it passes through the material. what photon energies in this beam of light are observed to be significantly reduced in intensity (“dark absorption lines”)? explain briefly.
Answers: 3
You know the right answer?
The arrows in the chart below represent phase transitions. Solid
3
Liquid
Gas
Questions
question
World Languages, 19.02.2020 05:49
Questions on the website: 13722361