Physics, 04.10.2020 14:01 latoyatuggle23

A liquid thermometer can be used to test for fevers. When body temperature increases, the liquid inside the thermometer expands and rises to show a higher
temperature reading. Which of the following explanations best describes the changes in thermal energy of the
particles during this specific example of heat transfer?
A. The tip of the thermometer is heated by radiation from the person's body. The particles of the thermometer tip then transfer heat
by convection through the liquid inside of it. The particles inside the liquid then convect heat causing the warmer particles to slow
down, rise, and expand.
B. The tip of the thermometer is heated by conduction from the person's body. The particles of the thermometer tip then transfer heat
by convection through the liquid inside of it. The particles inside the liquid then convect heat causing the warmer particles to slow
down, rise, and expand.
© C. The tip of the thermometer is heated by convection with the person's body. The particles of the thermometer tip then transfer heat
by conduction with the liquid inside of it. The particles inside the liquid then conduct heat causing the warmer particles to speed up,
rise, and expand
© D The tip of the thermometer is heated by conduction with the person's body. The particles of the thermometer tip then transfer heat
by conduction with the liquid inside of it. The particles inside the liquid then convect heat causing the warmer particles to speed up,
rise, and expand

Answers: 1

Show answers

Another question on Physics

Physics, 21.06.2019 22:00

Jason and mia are both running in a race. as they approach the finish line, you being the physicist that you are decide to time how long it takes them to reach the end of the race. when you start your stop watch (you can take this as time t = 0 s) you notice that mia is an unknown distance d ahead of jason and both are moving with the same initial velocity v_0. you also notice that jason is accelerating at a constant rate of a_j, while mia is deaccelerating at a constant rate of -a_m. jason and mia meet each other for the first time at time t = t_1. at this time (t = t_1) jason's velocity is two times that of mia's velocity, meaning v_j (t_1) = 2v_m (t_1). a) draw the position vs. time graph describing mia's and jason's motion from time t = 0 to time t = t_1. clearly label your axes and initial conditions on your graph. b) draw the velocity vs. time graph describing mia and jason's motion from time t = 0s to time t = t_1. clearly label your axes and initial conditions on your graph. c) how long from when the stop watch was started at t = 0s did it take mia and jason to meet? express your answer in terms of know quantities v_0, a_m, and a_j. d) when the stop watch started at time t = 0s, how far apart, d, were mia and jason? express your answer in terms of know quantities v_0, a_m, and a_j.

Answers: 1

Answer

Physics, 22.06.2019 09:00

Immediately upon reaching its lowest point, a falling pendulum bob has its greatest amount of energy, which is the initial amount of potential energy. a. heat; less than b. heat; more than c. kinetic; less than d. kinetic; more than

Answers: 3

Answer

Physics, 22.06.2019 15:20

Acarpenter builds an exterior house wall with a layer of wood 2.9 cm thick on the outside and a layer of styrofoam insulation 2.3 cm thick on the inside wall surface. the wood has k=0.080w/(m⋅k), and the styrofoam has k= 0.010 w/(m⋅k). the interior surface temperature is 19.0 ∘c , and the exterior surface temperature is -15.0 ∘c . a.)what is the temperature at the plane where the wood meets the styrofoam? celsius b.)what is the rate of heat flow per square meter through this wall? /m^2

Answers: 2

Answer

Physics, 22.06.2019 16:30

If anyone who can me with this hw? i would really appreciate it

Answers: 2

Answer

You know the right answer?

A liquid thermometer can be used to test for fevers. When body temperature increases, the liquid ins...

Questions