Physics, 22.08.2020 16:01 estherklein15ov3vx9

A large rock that weighs 164.0 N is suspended from the lower end of a thin wire that is 3.00 m long. The density of the rock is 3200kg/m3. The mass of the wire is small enough that its effect on the tension in the wire can be ignored. The upper end of the wire is held fixed. When the rock is in air, the fundamental frequency for transverse standing waves on the wire is 42.0 Hz. When the rock is totally submerged in a liquid, with the top of the rock just below the surface, the fundamental frequency for the wire is 28.0 Hz. What is the density of the liquid?

Answers: 3

Show answers

Answers

Answer from: michaelbernbenn5740

ρ_liquid = 1,778 10³ kg/m³

Explanation:

In a wire the speed of the wave produced is

v = √T/μ

wave speed is also related to frequency and wavelength

v = λ f

as they indicate that the frequency is the fundamental, there must be a single antinode in the center

L = 2λ

λ = 2L

Using the translational equilibrium equation

T -W = 0

T = W

let's substitute

2L f = √ W /μ

μ = W / 4 L² f²

μ = 164 / (4 3² 42²)

μ = 2.5825 10⁻³ kg / m

this is the linear density of the wire

Now let's analyze when the rock is submerged in a liquid, the thrust acts on the rock

B = ρ g V

when writing the equilibrium equation we have

T + B -W = 0

T = W - B

T = W - ρ_liquid g V (1)

to find the volume of the rock we use the concept of density

ρ_body = M / V

V = M /ρ_body

W = M g

V = W / g ρ_body

V = 164 / (9.8 3200)

V = 0.00523 m³

V = 5.23 10⁻³ m³

The speed of a wave on a string is

v = √ T /μ

speed is also related to wavelength and frequency

v = λ f

indicate that the frequency formed is the fundamental one, therefore it has a single antinode in the center and two nodes at the fixed points

L = λ/ 2

λ= 2L

we substitute and look for tension

2L f = √T /μ

T = 4L² f² μ

T = 4 3² 28² 2.5825 10⁻³

T = 72.888 N

We already have the volume of the rock and the tension on the rope, we can substitute in equation 1 and find the density of the liquid

T= W – ρ_liquid g V

ρ_liquid = (W -T) / gV

ρ_liquid = ( 164 – 72,888) / ( 9,8 5,23 10⁻³)

ρ_liquid = 1,778 10³ kg/m³

Answer from: Quest

i think it’s a. this is because if they measured the mass of something with a mass of 150g, then their final answer would have to be approximately 150g. though all of their answers are almost 150, rosa and tran have the closest answers (or the exact answer) to the accurate one.

Answer from: Quest

Neptune is the eighth planet from the sun. it was the first planet to get its existence predicted by mathematical calculations before it was actually seen through a telescope on sept. 23, 1846. irregularities in the orbit of uranus led french astronomer alexis bouvard to suggest that the gravitational pull from another celestial body might be responsible. german astronomer johann galle then relied on subsequent calculations to spot neptune via telescope. previously, astronomer galileo galilei sketched the planet, but he mistook it for a star due to its slow motion. in accordance with all the other planets seen in the sky, this new world was given a name from greek and roman mythology — neptune, the roman god of the sea.

Another question on Physics

Physics, 22.06.2019 00:30

What is relative velocity? in which condition is relative velocity known by adding the velocity of the first body and that of the second body

Answers: 1

Answer

Physics, 22.06.2019 03:30

As part of an industrial process, air as an ideal gas at 10 bar, 400k expands at steady state through a valve to a pressure of 4 bar. the mass flow rate of air is 0.5 kg/s. the air then passes through a heat exchanger where it is cooled to a temperature of 295k with negligible change in pressure. the valve can be modeled as a throttling process, and kinetic and potential energy effects can be neglected. (a) for a control volume enclosing the valve and heat exchanger and enough of the local surroundings that the heat transfer occurs at the ambient temperature of 295 k, determine the rate of entropy production, in kw/k. (b) if the expansion valve were replaced by an adiabatic turbine operating isentropically, what would be the entropy production? compare the results of parts (a) and (b) and discuss.

Answers: 3

Answer

Physics, 22.06.2019 06:30

5submission this assignment is worth 20 points total. you are required to submit the following by next lab: 1. (3 points) determine the equation for the output angular velocity ω2 = θ˙ 2 as a function of θ1, ω1 = θ˙ 1 and α. you must show all your work to receive credit. 2. (2 points) use the result of problem#1 to plot ω2 over 0 ≤ θ1 ≤ 360deg with ω1 = 360deg/sec. do this for α = {10,30}deg. show the results on the same plot and properly label the axes, title, legend. for this you can use matlab or ms excel. 3. (3 points) determine the equation for the output angular acceleration ω˙ 2 and create a plot similar to the one in problem#2. 4. (10 points) submit plots of the results (ω2 and ω˙ 2) obtained from creo/mechanism and compare them to results of problem#2 and problem#3. note that you should do these comparisons for the two cases with α = {10,30}deg. 5. (2 points) provide a brief explanation of the results. did they match? what are the implications as misalignment angle increases?

Answers: 3

Answer

Physics, 22.06.2019 09:30

Along the line connecting the two charges, at what distance from the charge q1 is the total electric field from the two charges zero? express your answer in terms of some or all of the variables s, q1, q2 and k =14ï€ïµ0. if your answer is difficult to enter, consider simplifying it, as it can be made relatively simple with some work.

Answers: 3

Answer

You know the right answer?

A large rock that weighs 164.0 N is suspended from the lower end of a thin wire that is 3.00 m long....

Questions