If the magnetic field is held constant at 3.0 T and the loop is pulled out of the region that contains the field in 0.2 s, what is the magnitude of the average induced emf in the loop

emf = 15 * Area  and if A is given in square meters, the units of the emf will be Volts

Explanation:

Assuming that the area of the loop of current (A) is known, the magnitude of the induced emf can be calculated using Faraday-Lenz's Law:

and if the area (A) is given in square meters, the emf will directly come in units of Volts.

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).

what experimental evidence led scientists to change from the previous model to this one?

a few of the positive particles aimed at a gold foil seemed to bounce back.

the colors of light emitted from heated atoms had very specific energies.

experiments with water vapor showed that elements combine in specific proportions.

cathode rays were bent in the same way whenever a magnet was brought near them.