You have a lightweight spring whose unstretched length is 4.0 cm. First, you attach one end of the spring to the ceiling and hang a 1.8 g mass from it. This stretches the spring to a length of 5.1 cm . You then attach two small plastic beads to the opposite ends of the spring, lay the spring on a frictionless table, and give each plastic bead the same charge. This stretches the spring to a length of 4.3 cm . Requried:
What is the magnitude of the charge (in nC) on each bead?

2.2nC

Explanation:

Call the amount by which the spring’s unstretched length L,

the amount it stretches while hanging x1

and the amount it stretches while on the table x2.

Combining Hooke’s law with Newton’s second law, given that the stretched spring is not accelerating,

we have mg−kx1 =0, or k = mg /x1 , where k is the spring constant. On the other hand,

applying Coulomb’s law to the second part tells us ke q2/ (L+x2)2 − kx2 = 0 or q2 = kx2(L+x2)2/ke,

where ke is the Coulomb constant. Combining these,

we get q = √(mgx2(L+x2)²/x1ke =2.2nC

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).

answer: the exterior temperature of commercial jet planes as they leave the stratosphere and return to the ground increases steadily.

explanation:

the lower most layer of atmosphere is troposphere which extends from 0 to 12 km above the surface of the earth. the temperature initially decreases as distance is increased from the earth's surface. commercial jets fly in lower part of the stratosphere. the stratosphere extends upto 50 km. the temperature in stratosphere starts rising again due to presence of ozone which traps the uv rays.

thus, when the planes leave the stratosphere and return to the ground, the exterior temperature increases steadily.