Physics, 01.08.2020 01:01 antionette1

Which of the following real-world examples models linear motion?

Answers: 1

Show answers

Another question on Physics

Physics, 21.06.2019 17:20

Your 249 ml cup of coffee is too hot to drink when served at 82 degree celsius. what is the mass of an ice cube taken from a -21 degree celsius freezer, that will cool your coffee to a pleasant 54 degree celsius. specific heat of the water is 4190 j/kg c, specific heat of ice is 2090 j/kg c, heat of fusion of ice is 3.33 x 10^5 j/kg

Answers: 3

Answer

Physics, 21.06.2019 17:30

Awheel rotates without friction about a stationary horizontal axis at the center of the wheel. a constant tangential force equal to 82.0 n is applied to the rim of the wheel. the wheel has radius 0.150 m . starting from rest, the wheel has an angular speed of 12.8 rev/s after 3.88 s. what is the moment of inertia of the wheel?

Answers: 3

Answer

Physics, 22.06.2019 00:00

(science)study the following ocean currents map. an ocean currents map is shown. on the map the locations for san diego, california and savannah, georgia are marked. there is a looping current from the north past san diego and a looping current from the south near savannah which statement is most likely correct about the average temperatures in san diego, california as compared to savannah, georgia? it is higher in savannah because of the cool ocean currents from the south. it is higher in savannah because of the warm ocean currents from the north. it is lower in san diego because of the warm ocean currents from the south. it is lower in san diego because of the cool ocean currents from the north.

Answers: 2

Answer

Physics, 22.06.2019 03:10

Athin plate moves between two parallel, horizontal, stationary flat surfaces at a constant velocity of v = 7.5 m/s. the two stationary surfaces are spaced 4 cm apart, and the medium between them is filled with oil whose viscosity is 0.9 n·s/m2. the part of the plate immersed in oil at any given time is 2 m long and 0.5 m wide. if the plate moves through the mid-plane between the surfaces, determine the force required to maintain this motion. what would your response be if the plate was 1 cm from the bottom surface (h2) and 3 cm from the top surface (h1)? if the plate moves through the mid-plane between the surfaces, the force required to maintain the motion will be n. if the plate was 1 cm from the bottom surface (h2) and 3 cm from the top (h1) surface, the force required to maintain the motion would be n.